There are several Tekonsha brand brake controllers, each with their own troubleshooting steps. The main controller differences include the controller activation circuitry and the way each controller type is mounted. The Tekonsha Voyager brake controller uses pendulum activation and is sensitive to the controller mounting . I traced the red wire to the connector that connects into the trucks wiring . The installation instructions say to check for corrosion on the plug contact or loose wiring.
Most likely that is the problem , you might find that just wiggling the connector will bring it back to life.
The next thing you could try is to test the volt .
I have used this unit for years and have had occasional problems that have self correcte but never this problem. Troubleshooting Tekonsha Voyager Brake Controller. Expert Reply: The green light on the . Question: is there any way to bech test my brake controller. It will not pair with the hand held unit.
Hello, I can not get my new Tekonsha Pbrake controller to recognize the trailer connection. It always says trailer not connected. I have visually inspected almost all of the wiring, truck and trailer. The lights all work correctly to include brake lights but no . Refer to manufacturer installation instructions and specs f. Can not set the power when manual power knob is placed to the left.
You will then be able to monitor the battery voltage supplied to the unit, black wire, the voltage supplied when the brake pedal is presse red wire, . I connected the unit the way the directions advised. I check the trailer and found no problems. Now my Primus brake controller shows 0. Sometimes it will stay on and work and other times blinks. I ve checked grounds but cant get them to work. Brakes will work if voltage is applied.
Utilizes Plug-N-Play port for 2-plug adapters. Self-diagnostics features will illuminate LED readout when issues occur. How to install and program the Tekonsha P3 .
No comments:
Post a Comment
Note: only a member of this blog may post a comment.