Country, Three-phase voltage (volts), Frequency (hertz), Number of wires (not including the ground wire ). United States, 1V, HZ, USA. Mexico, 1V (127V), HZ, USA. Voltage , frequency, and plug type vary widely, but large regions may use common standards.
Physical compatibility of receptacles may not ensure compatibility of voltage , frequency, or connection to earth ground.
This article lists the plug type, voltage and frequency commonly expected for many territories.
Some city areas may use standards different from that of the surrounding countryside (e.g. in Libya).
Regions in an effective state of anarchy may have no central electrical authority, with electric power provided by incompatible private sources. Many other combinations of voltage and utility frequency were formerly use with . International Line Voltage Standards. There is no standard mains voltage throughout the world and also the frequency, i. However, 1volts nominal may be referred to by equipment design standards as this is the Nominal Utilization Voltage as defined by ANSI C84. Volt: 1volts is the common lower voltage supplied by US and Canadian utilities.
It is provided by the utility as 1volts ±. European plugs are not compatible with Canadian electrical sockets. Limitations to Steady State Operating Voltage Levels. For consistency with all Canadian Standards Association (CSA) approved equipment and requirements from regulatory bodies such as the Independent Electrical System Operator ( IESO), the Northeast Power Coordinating Council (NPCC), and the . The design, construction and installation of all electrical equipment shall meet the standards set out in the Canadian Electrical Code, Part I , in so far as is . I of an item of the schedule to this . Due to line drops, the actual voltage into your home will vary with the distance from the transformer on the pole.
It may be several volts above 1if close, and as low as 1if some distance away. Just to cross your eyes further, the actual standard is . The term high voltage usually means electrical energy at voltages high enough to inflict harm on living organisms. Equipment and conductors that carry high voltage warrant particular safety requirements and procedures. The system allows SCC-accredited Standards Development Organizations (SDOs), and members of the .
No comments:
Post a Comment
Note: only a member of this blog may post a comment.