Forum discussion: Arris TM8online light blinking green and the DS light is pure amber. I reset it once and it still does this. Yesterday my Internet suddenly went down.
The power and link lights go solid green. The DS flashes amber, eventually going solid amber.
Receive, On solid green or blue.
Link, Solid amber or blue (depending on connection type) when connected or flashing when receiving or sending data.
The ARRIS TM822G modem provides high-speed Internet access and supports the use of up to two Optimum Voice lines. Complete list of cable modem light patterns (for cable modems distributed to broadband customers). If the cable modem is not in standby, proceed to the next section ( Resetting the Cable Modem ). On the cable modem , the online indicator light is flashing yellow, but should be solid green (when attached via ethernet cable to the router). Solved: my new moden ( arris tm822) has an orange flashing light all the time ? Re: No Internet connection - US and DS lights blinking on modem.
Please refer to the Verifying the Cable Signal section of this document to troubleshoot the line signal. The modem may also be in Standby mode. If it remains flashing and never turns . The first thing you need to do is reboot your modem by unplugging the power from the back of the modem. Leave it unplugged for about seconds then plug it back in. Unplug the network cable and plug it in again, ensuring . Plug the cable modem into the wall outlet.
Off, Flashing , Solid Green, Solid Blue, Solid Amber. Downstream channel is connected. Blinking , AC power has failed. US (Upstream), Soli Connected to the Internet.
Off, Your computer or router is not connected to the Ethernet port. Off, The Internet is not available. Restart your computer or other devices connected to the cable modem.
Online , Soli The Internet is available. Wait seconds, then reinsert any batteries and reconnect the power to the modem. Wait two minutes to allow the modem to connect.
A solid light indicates the channel connection is acquired. Sen When the light is flashing , the modem is scanning for the send channel connection.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.