Check the wiring diagram that comes with the kit and mark the back of the new fuel gauge with symbols for each post: “S” for the sender, “G” or “—” for the groun and “I” for the ignition. Install the new gauge, reconnect the wiring and turn on the power. The fuel gauge should now show the correct fuel level . INSTRUCTIONS FOR THE INSTALLATION OF THE ELECTRIC TEMPERATURE, . VOLT NEGATIVE GROUND ELECTRICAL SYSTEMS.
LIGHT BULB, IF SUPPLIE IS 12.
Over tightening may result in damage to the instrument and may void your warranty.
These instructions concern only fuel gauge installations. SPECIAL CAUTION should be taken when working on or near tanks that have, or have had , fuel in them. Be certain to use strande insulated wire not lighter that AWG that is . Electric Sending Unit to Fuel Gauge Wiring Diagram . For your safety and for best , pre-read the following instructions completely before installation. We, at Moeller Marine, thank you for your purchase.
The gauge is mounted in or on the vehicle panel while the sender is installed in the engine block, transmission, differ- ential, or fuel tank, as required. See chart and wiring diagram for cor- rect application. Fuel gauge troubleshooting begins with isolating the problem either to the gauge, sending unit, fuse or wiring. As with any electrical troubleshooting, it is best to check the fuse and all wiring connections are clean, tight and free of . Testing Boat Fuel Gauge and Fuel Sending Unit.
Boat fuel gauges can be troublesome. Electronic Tachometer Mk- Wiring Diagram , 84kb. ETB Fuel Level Sensor (Float-arm type) - Notes . The original makers of SMITHS Instruments”. Caerbont Automotive Instruments Ltd.
To assure proper functioning of this instrument, please read instructions thoroughly before installing. CAUTION FOR ALL GAUGE INSTALLATION (AMMETERS EXCLUDED). Available in all standard face and bezel colours to ensure continuity with all other gauges.
For oil pressure it will typically be light blue ( LTBL) Water temperature will be tan (Tn) and fuel gauge pink (Pk).
No comments:
Post a Comment
Note: only a member of this blog may post a comment.