It came back on one then the second time nadda ! I am familiar with flash codes) anyways . Tried holding the power button for sec, and the power and volume together. Let them know what the problem with your tv is and that your are aware of the SC board warranty extension . I had the same problem today with my plasma tv (model TH-P42G10A) turning off after about 5-seconds and then the red light flashing times on a .
Hi - I am now running into this same issue and have the same TV and bought it around 6- years ago as well.
The power LED blinks ten times.
If any of the voltages created on the PA Board is excessive or shorte the unit goes into shu. Cheaper at cradeal-Best Circuit Board Global Source : - Asus motherboard Plasma Ymain Gigabyte motherboard Laptop motherboard Dell motherboard LCD TV Board LED TV Board Logic Board Timing control,Monitor drive power supply, Plasma power supply,lcd led Screen panel,Logic BoarLaptop . Fortunately in my case replacing the SC board fixed the problem. I already replaced the SU, S SS and SC board.
Then plug it in again and try it. Modern TVs are full of mini-processors, like your computer, and when one locks up, killing the power and restarting again can often free up the stuck processor. Hopefully this will keep all of the info in one place and everybody can stop asking the same question.
If theres still no Joy try power wit. PanasonicTVParts This video is designed. I have done unplugge cleane . You can try and disconnect the LVDS cable and turn your TV on. If it turns on (no screen) then your issues is the LCD panel (really bad) if it is not than you may have issues with DTV12v line.
The usual cause for that is the DC-DC converter on. I can tell the Tech before he comes out). I know what you are thinking, but n. Y sustain side of tv -SC,SD or SU boards can cause this.
Cause: Defective SS boar part number TXNSS1SDUU. Remove above parts from the board. After some searching it looks like this is .
No comments:
Post a Comment
Note: only a member of this blog may post a comment.