Invisible fence flashing green light

When you first insert the battery into your receiver, the status light will flash red and green. This indicates that the receiver has started properly. Once starte the status light will continue to flash green once every seconds indicating normal operation.

In the event that the light does not flash , check the battery to be sure that . Status Light and Audible Alarm Troubleshooting.

The low battery light will begin flashing when it is time to recharge the battery.

All invisible fence systems have some type of indicator light on the transmitter that shows if the system is functioning and there is no break in the boundary wire.

If all lights go out or no warnings . It should either flash red lights or set off an alarm. Dogfence Troubleshooting Guide. Should the red LED flash continuously while your . ProbleThe Transmitter is beeping and the display is flashing on and off.

Make certain that each boundary wire is connected properly to the terminal connections on the transmitter. Commercial Dog Collar in the Dog Fence Industry. The translucent nature of the case allows you to see various lights that are incorporated within the receiver itself.

A solid green light that lets you know the unit is charging. I am wondering if the board is bad and not putting out enough current? If turning up the two boundary . Also, check the lights on the transmitter occasionally.

For FM Transmitters: The red light shows you have AC power to the system, the blinking green light shows there are no breaks in the wire. Note: FM transmitters are labeled: . If drying the receiver does not work, try it again and again. Watch for the flashing light on the collar. The green CABLE OK LED should flash and the red POWER BATT LED should also flash.

If this is not the case, the transmitter needs to be replaced. Disconnect one of the ends of your short loop from its terminal. The audible warning should sound and the CABLE BREAK LED should illuminate.