The quickest way to test is by disconnecting the main board from the power supply boar plug in the power supply boar after that you should see some lights. Treat this like you would a No Power situation. I had several bulging capacitors, . If the television is outside of the one year warranty then you are welcome to use the following . I left the room and came back and no picture.
Led flashes at power on, no picture, but can hear the TV running and the digital optical input has its red light on.
Unless you have some experience in electronic repair, not much you can usually do.
The red LED on the remote just keep blinking. But my to is not getting on after power on the tv ,it seems that it try to on but after some seconds the red light blink . What does it meen when red light . The power LED blinks ten times. If any of the voltages created on the PA Board is excessive or shorte the unit goes into shu. Any help and advice is appreciated!
Keep holding them while plugging the set back in, and power on. If it stays on, use your remote and arrow right then look for fact init and set it to on. Then arrow back up to fact init and hit enter.
If the power indicator LED on the glasses are blinking continuously, then this indicates that the battery needs replacing. However, the red LED on the TV is not visible to the human eye, due to the wavelength of the signal. Similarly if you wait an hour or more it will start fine.
The screen stays black, and the red LED power light blinks slowly. Samsung makes most Plasma screens on earth, h. TV does not react to the remote. You will have to unplug it and remove the back of the set. Then check the power board for any blown fuses or other components.
You do want to post pictures of your boards with your question so.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.