The Toner, Drum and Error LEDs are off. Once all four LEDs are lit, release Go. If you are not able to print or scan after upgrading to Windows 1 reinstall the drivers by referring to the FAQ below.
Click here to see how to reinstall the drivers. This will turn off the drum warning light on the printer.
Your brother laser printer should now be factory reset and all the error lights (toner, drum and error ) should have stopped flashing.
The Status Monitor states Jam Tray Jam Tray Jam MP or Jam Inside.
Put drum unit and toner cartridge assembly. The Drum and Error LEDs are flashing. Please follow the steps below to solve the probleThe drum unit needs to be cleaned. Please refer to the instructions, Clean the corona wire of the drum unit. If your LEDs still show the same error indication after you have cleaned . Open the front cover and leave open while completing the following steps.
The best way to get assistance is to call Official help desk Directly. Brother Help desk can be reached for any queries or . Press the Go button to print the remaining data in the printer memory. The toner, drum and error lights should remain lit. Your computer will fail and will not find . Release, pause and press again five times.
But some of errors are necessary to. LED indication at Operator Calls. If the error is not cleared after turning the power switch off and then back on, press Go button, the LEDs will light up as the images below to identify the error. The Ready and Error LEDs will flash as the job is being canceled.
Leave the machine for minutes with the power on. The drum light would flash and any attempt to print resulted in an error.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.