The power LED blinks ten times. If any of the voltages created on the PA Board is excessive or shorte the unit goes into shu. Pull the plug and with the power disconnected hold the power button on for seconds.
After at least the seconds plug the tv in and try to start it. If theres still no Joy try power wit.
How about NO blinking light when power on the TV ?
Firstly, please take the batteries out of the remote to see if this is causing the problem.
Alternatively, use the channel up key on the television set itself to see if the television responds and switches on. I had the same problem today with my plasma tv (model TH-P42G10A) turning off after about 5-seconds and then the red light flashing times on a . I was able to use a band aid solution below that seems to . If you are unable to resolve the blinking power indi. Since the original fuse is inside the transformer the new one must be installed on the outside of the transformer. Now before you install the fuse, you should be able to tie the wire together and the TV will power up confirming the bad fuse.
For example, when you use the remote control to turn the TV off, the Power LED Indicator blinks orange for about seconds until the cooling fan stops running. No picture were present, fans off, power indicator off. You can try and disconnect the LVDS cable and turn your TV on.
If it turns on (no screen) then your issues is the LCD panel (really bad) if it is not than you may have issues with DTV12v line. The usual cause for that is the DC-DC converter on. I will post , down to the earth, please keep in touch. The green light or red light flashing denotes an error code.
Just how many times does the red light flash? This is your error code, and gives you the problem. Samsung makes most Plasma screens on earth, h. Fortunately in my case replacing the SC board fixed the problem.
This video will show you how to fix the problem yourself and save $800!
No comments:
Post a Comment
Note: only a member of this blog may post a comment.