Conversely, if the mechanism is turned to the on position, there is current flow. Unswitched outlets, on the other han have contacts that are permanently connected to the wiring and are therefore always live. Often people remove old light fittings without identifying the switched live wire.
The luminaire must be connected to an unswitched live supply fed by the normal lighting sub-circuit in that location. Check the green LED indicator illuminates to indicate the battery is charging.
Maintained luminaires only - check the lamp illuminates when the switched supply is turned on.
These instructions contain important safety information, read and follow them carefully.
ISOLATE SWITCHED AND UNSWITCHED MAINS AND NEGATIVE BATTERY. This will fully charge the battery. Connect the unswitched live for hours. Check that both LED indicators glow red and the lamp filaments are intact. Ensure mains supply is turned OFF.
Terminal is suitable for looping. Keep finger marks off plastic panel. Repeat for other bracket on opposite side. This is the most straightforward arrangement.
This contains live , neutral and earth wires. These are permanently connected to the supply. On the metal terminal of the chassis. Fit diffuser back to housing, ensuring all clips are fastened.
Sensor supplied loosely connected for packing. Emergency a) Pull lamp holders up through slots in gear tray, ensure they. Please see additonal leaflet for details. Push geartray back into position, ensuring it secures back into housing clips. LUnswitched live (Emergency light battery charging).
If the model is equipped with heat element this will also be connected to L2. Typical Conversion Wiring Diagrams. International Conference for Advanced Neurotechnology In the past decades significant new advances have been brought on the joint problems of scaling neurosc. If the wiring diagrams below are not appropriate consult Cooper.
Lighting and Security Ltd technical support.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.