Interior stair railing height code

Guidelines to stair handrail code pertaining to both rails and guards for interior stairs and landings. Switching from one rail to another may be just the thing that causes you to lose concentration and fall, mid-switch. How ironic, painful, and dumb that your railing would be the thing that causes you to fall. Exception: A floor or landing is not required at the top of an interior flight of stairs , including stairs in an.

This article series explains and illustrate the requirements for safe, useable hand railings on steps and stairs , both interior and exterior stairways.

Stair railings on open sides that are inches or more above the surface below shall be equipped with midrails approximately one half way between the steps and the top rail.

This Section applies to the design and construction of interior and exterior stairs , steps , ramps, railings and guards.

The clear height over ramps shall be not less than,. This article describes procedures for performing safety inspections of the balusters used on indoor or outdoor stairs , railings , landings. There are, of course, national codes (the National Building Code of Canada, or NBC) and provincial ones (e.g., Quebec Construction Code ). Top of handrail to be between 34” and 38” above line drawn through front.

It applies to dwellings and small residential buildings. In either case you are allowed to build taller guardrails as long as they conform to all other requirements stated in the code. In the case of guardrails for stairs there is an . Stair risers and treads, as well as width and headroom, are dictated by building code , which itself is often dictated by goo common sense. Alternate stairway types: Spiral . The need for secure footing between floor levels is the foundation of building code requirements for stairs.

Railings are required on stairways to prevent falls and provide support. The following rules apply equally to stairs and ramps, unless noted otherwise. Guardrails and areas with tiered seating are not discussed here.

Projects Under the Seattle Residential Code. Single family houses , duplexes and townhous- es have the following requirements. Handrails shall not project more than 4. RESIDENTIAL STAIR , GUAR AND HANDRAIL REQUIREMENTS. A flight of stairs shall not have . The minimum width of stairs shall be inches. Intermediate rail means the intermediate lateral . To ensure safety and durability, contractors must follow the standards in the Ohio building code that define stair components such as rail height.

The state of New Jersey has specific building code mandates that cover how stairs are constructe where they are require and the dimensions they must.