Wiring a pull switch diagram

Always turn off the electric to the circuit you are working on. Connect the hot wire to the brass scr. Ensure the electricity is isolated from the switch by following the instructions mentioned above. Before use please read carefully and use in accordance with these safety wiring instructions.

Before commencing any electrical work ensure the supply is switched off at the mains.

The two black wires have been connected to .

I`m trying to replace my pull cord ceiling switch for the electric shover.

Does the LOAD side of the ceiling switch go to the consumer (electric shower)? Pull chain light fixtures are easy to replace when the switch wears out or breaks. FEED side of switch goes back to the electric meter? We show you how to replace it safely and quickly. Circuit diagram for wall lights.

Diagram for the circuit required for independently switched wall lights. Isolation switch for use in bathrooms and special areas for isolating circuits. Unlike other fan installations, it does . Guidelines for using the following wiring diagrams. Switch off the mains electricity supply before attempting any sort of fan installation or maintenance.

All of these diagrams are meant to be used as guides only. Electrical Wiring Forum - GardenWeb. Make sure you turn the power off to the light switch at your consumer unit. Unscrew the two retaining screws on the switch and pull away the switch.

This stops you pulling away the paint work on . The other pull chain switch is for the light fixture. All pull chain switches are not the same, so it is best to follow these instructions : Identify the electrical circuit to the ceiling fan and turn it off. Carefully open the housing where the pull chain switches are located.

Dismount the faulty pull chain switch so you can see the wiring . Simply release the live and neutral terminal screws, pull the wires out and connect them to the (correct!) terminals of the new switch. Single Pole Single Throw (SPST) Pull Chain Switch. A - This is the most common loop-in wiring arrangement you are likely to see.

There is an important safety element to these products, as they are being used in moist environments it is important the operator is as far away from the electricity as possible, hence the string pull.